Iota I-32 Manuel d'utilisateur télécharger pdf

IMPORTANT SAFEGUARDS

When using electrical equipment, basic safety precautions should always be followed, including the following:

READ AND FOLLOW ALL SAFETY INSTRUCTIONS

1. CAUTION – To prevent electrical shock, do not mate unit connector until installation is complete and A.C.

power is supplied to the unit.

2. CAUTION – This ﬁxture provides more than one power supply output source. To reduce the risk of electrical

shock, disconnect both normal and emergency sources by turning off the A.C. branch circuit and by discon-

necting the unit connector.

3. CAUTION – This is a sealed unit. The integral, high temperature Ni-Cad battery is not replaceable. Replace the

entire unit when necessary and recycle or dispose of the nickel-cadmium battery properly.

4. DO NOT USE OUTDOORS. The I-32 is for use with grounded, UL Listed, indoor ﬁxtures. Not for use in heated

air outlets or hazardous locations.

5. The I-32 requires an unswitched A.C. power source of either 120 or 277 volts. Properly cap the unused A.C.

lead.

6. The I-32 and A.C. ballast must be on the same branch circuit.

7. Do not mount near gas or electric heaters.

8. The I-32 should be mounted in locations and at heights where it will not readily be subjected to tampering by

unauthorized personnel.

9. The I-32 will cold strike and operate one 2′ through 4′ (20-40W) instant start, rapid start, U shape or circline,

T8 through T12 or 28W T5 ﬂuorescent lamps, including energy saving and long compacts for 90 minutes at

reduced light output.

10. The I-32 is compatible with all A.C. magnetic and electronic ballasts including multiple lamp ballasts with one

lamp operating in the emergency mode.

11. The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.

12. Do not use this equipment for other than intended use.

13. Install in accordance with the National Electrical Code and local regulations.

14. Installation and servicing should be performed by qualiﬁed personnel.

15. Lighting ﬁxture manufacturers, electricians, and end-users need to ensure product system compatibility before

ﬁnal installation.

SAVE THESE INSTRUCTIONS

I-32

TBTS SERIES D

EMERGENCY

LIGHTING EQUIPMENT

INSTRUCTION MANUAL

P.O. BOX 11846 TUCSON, AZ 85734

(520) 294-3292 • FAX (520) 741-2837

www.iotaengineering.com

1 2 3 4

Résumé du contenu

Page 1 - INSTRUCTION MANUAL

IMPORTANT SAFEGUARDSWhen using electrical equipment, basic safety precautions should always be followed, including the following:READ AND FOLLOW ALL S

Page 2 - INSTALLATION INSTRUCTIONS

Page 27/8" BUSHINGFIXTUREBALLAST CHANNEL COVERPLASTIC TUBETBTSFIXTURE LENS4. INSTALLING THE THREADED BODY TEST SWITCH (TBTS) Recessed Troffer F

Page 3 - TESTING & MAINTENANCE

Page 35. WIRING THE A.C. INPUTA. The I-32 and A.C. ballast must be on the same branch circuit.B. The I-32 requires an unswitched A.C. power source of

Page 4 - TYPICAL WIRING DIAGRAMS

Page 4TYPICAL WIRING DIAGRAMSFor wiring diagrams of ballasts not shown, consult our Customer Service.Rev. 07151368432-0611. ONE LAMP RAPID START BALL

Commentaires sur ces manuels

Pas de commentaire

Iota I-32 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Fournisseurs d'énergie Iota I-32. IOTA I-32 User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Fournisseurs d'énergie Iota I-32